User Manual
Table Of Contents
- Table of contents
- About this manual
- Introducing the Drystar 5500
- Basic operation (operator mode)
- Advanced operation (Key-operator mode)
- Overview of Key-operator functions
- Stopping the printing process
- Viewing printer information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Performing the calibration procedures
- Installation
- Quality control for general radiography applications (DT 2 B & DT 2 C)
- Quality control for mammography application (DT 2 Mammo) (optional)
- Controlling the Drystar 5500 via a remote PC (with browser)
- System description
- Preventive maintenance and replacements
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Remarks for HF-emission and immunity
- Remarks for HF-emission and immunity
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in an electromagnetic environment in which the radiated high frequency disturbance variabl...
- Remarks for HF-emission and immunity
- Index
28
2900H EN 20071108Introducing the Drystar 5500
DRYSTAR 5500/5503 REFERENCE MANUAL
The status indicator LED
At the right side of the display, a LED indicates the status of the Drystar 5500:
The control buttons
Two control buttons have been provided:
Audio signals
The Drystar 5500 gives status information via beeps. The length of the beep
indicates the response of the system to a key command.
• A short beep means that Drystar 5500 has accepted the key command and
is starting the operation.
• A long beep means that you have pressed a non-active key or that the
Drystar 5500 has rejected the key command.
Color / Light Status Action
Green
Constant
Ready (stand-by) Proceed.
Blinking
Busy or in Key-
operator mode
Wait.
Red
Blinking
Warning status Check the display for messages.
Refer to ‘Checking the status
indicator LED’ on page 195.
Constant
Error status
Unlock button
• To safely unlock the printer for accessing the
input trays or opening the covers.
Power button • To power on or off the printer.
Do NOT press the Power button without first following the procedure to
stop printing when the Drystar 5500 is busy printing a film. Refer to
‘Switching off the Drystar 5500’ on page 36.
Certain conditions can cause an interval beep. An interval beep accompanies an
error or warning message. Refer to ‘Troubleshooting checklist’ on page 194 .