User Manual
Table Of Contents
- Table of contents
- About this manual
- Introducing the Drystar 5500
- Basic operation (operator mode)
- Advanced operation (Key-operator mode)
- Overview of Key-operator functions
- Stopping the printing process
- Viewing printer information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Performing the calibration procedures
- Installation
- Quality control for general radiography applications (DT 2 B & DT 2 C)
- Quality control for mammography application (DT 2 Mammo) (optional)
- Controlling the Drystar 5500 via a remote PC (with browser)
- System description
- Preventive maintenance and replacements
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Remarks for HF-emission and immunity
- Remarks for HF-emission and immunity
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in an electromagnetic environment in which the radiated high frequency disturbance variabl...
- Remarks for HF-emission and immunity
- Index
218
2900H EN 20071108Troubleshooting
DRYSTAR 5500/5503 REFERENCE MANUAL
Start-up errors
Error messages while the printer starts up
The table below lists the possible error messages which can appear on the
display of the control panel while the printer starts up.
After starting up the Drystar 5500, the printer performs a selftest. A progress
indicator will show the proceeding of this self test. During the self test, a
number of messages can appear, meaning that the selftest has failed.
Key selftest failed
In case the Key selftest has failed, following message appears:
Error message Cause of error
Error display failure (Firmware) ‘Key selftest failed’
Error system failure
‘Key selftest failed due to no
communication between Key and CPU’
Error self test failure (Firmware) ‘Software selftest failed’
Contact your local service organization in case the selftest fails.
Error messages can also appear when the printer has already started up. Refer to
‘Checking error messages’ on page 196.
ERROR
Display failure