User Manual
Table Of Contents
- Table of contents
- About this manual
- Introducing the Drystar 5500
- Basic operation (operator mode)
- Advanced operation (Key-operator mode)
- Overview of Key-operator functions
- Stopping the printing process
- Viewing printer information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Performing the calibration procedures
- Installation
- Quality control for general radiography applications (DT 2 B & DT 2 C)
- Quality control for mammography application (DT 2 Mammo) (optional)
- Controlling the Drystar 5500 via a remote PC (with browser)
- System description
- Preventive maintenance and replacements
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Remarks for HF-emission and immunity
- Remarks for HF-emission and immunity
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in an electromagnetic environment in which the radiated high frequency disturbance variabl...
- Remarks for HF-emission and immunity
- Index
180
2900H EN 20071108System description
DRYSTAR 5500/5503 REFERENCE MANUAL
Changing the film format of the trays
The Key-operator can adjust the film size setting of both the input trays and
the output tray (8x10” up to 14x17” film sizes).
First, the Key-operator has to perform a mechanical modification. After this
modification, the ‘film format’ parameter is automatically read from the Film
Identification tag when the new film pack is loaded.
Proceed as follows to perform the mechanical modification:
1 Make sure that the printer is in ‘Ready’ mode.
2 Press the Unlock button to unlock the trays.
3 Open the input tray you want to adapt.
Never load another film format when the input tray is not empty. Intermediate
changing of film formats increases the risk for dust, which can damage the thermal
print head (TPH).
The system performs an automatic calibration when the film format has been
changed.
You have 5 seconds to open the input tray. If you do not open the tray within that
time, the first screen (step 1 or 5 respectively) is presented again, or printing is
resumed when a job is received for which media is available.