User Manual

Table Of Contents
146
2900H EN 20071108Advanced operation (Key-operator mode)
DRYSTAR 5500/5503 REFERENCE MANUAL
Establishing the image geometry reference values for general radiography
applications (DT 2 B and DT 2 C)
To establish the image geometry reference values, proceed as follows:
1 Print the QC general radiography test image or use the previously printed test
image.
You should obtain an image looking like this (without the dimensions A and B):
QC general radiography test image
LowLow Base + FogBase + Fog
Max (100%)Max (100%)
HighHigh MidMid
IdentificationIdentificationIdentificationIdentification
Initials: __________Initials: __________Initials: __________Initials: __________
Base + Fog: ______________Base + Fog: ______________Base + Fog: ______________Base + Fog: ______________
Low Density: _____________Low Density: _____________Low Density: _____________Low Density: _____________
Mid Density: _____________Mid Density: _____________Mid Density: _____________Mid Density: _____________
High Density: ____________High Density: ____________High Density: ____________High Density: ____________
Max Density: _____________Max Density: _____________Max Density: _____________Max Density: _____________
Density
Difference (High - Low): ___________
Density
Difference (High - Low): ___________
Density
Difference (High - Low): ___________
Density
Difference (High - Low): ___________
Date: __________Date: __________Date: __________Date: __________
Time: _________
_
Time: _________
_
Time: _________
_
Time: _________
_
Daily density testsDaily density testsDaily density testsDaily density tests
Weekly spatial resolution tes
t
Weekly spatial resolution tes
t
Weekly spatial resolution tes
t
Weekly spatial resolution tes
t
Quality Control Test ImageQuality Control Test Image
(Version 3
)
Sets of dots visible? Yes NoSets of dots visible? Yes NoSets of dots visible? Yes NoSets of dots visible? Yes No
Dimension B
Dimension A
1 2