User Manual
Table Of Contents
- Table of contents
- About this manual
- Introducing the Drystar 5500
- Basic operation (operator mode)
- Advanced operation (Key-operator mode)
- Overview of Key-operator functions
- Stopping the printing process
- Viewing printer information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Performing the calibration procedures
- Installation
- Quality control for general radiography applications (DT 2 B & DT 2 C)
- Quality control for mammography application (DT 2 Mammo) (optional)
- Controlling the Drystar 5500 via a remote PC (with browser)
- System description
- Preventive maintenance and replacements
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Remarks for HF-emission and immunity
- Remarks for HF-emission and immunity
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in an electromagnetic environment in which the radiated high frequency disturbance variabl...
- Remarks for HF-emission and immunity
- Index
127
2900H EN 20071108 Advanced operation (Key-operator mode)
DRYSTAR 5500/5503 REFERENCE MANUAL
Using the installation wizard
When you install the Drystar 5500, the installation wizard will guide you
through the complete installation procedure.
The Installation wizard consists of three steps:
• ‘Entering the printer network settings’ (page 130),
• ‘Entering modality-specific settings’ (page 135),
• ‘Saving the configuration’ (page 139).
When you have entered the required data, the installation is complete.
In case the display software has been updated (e.g. when installing language files),
the ‘Updating display software’ screen is displayed during the downloading of the
display software:
Although the Installation wizard consists of three separate steps, these steps cannot
be performed separately.
To change the settings once the installation has completed, refer to ‘Changing the
configuration settings’ on page 69.