User Manual
Table Of Contents
- Table of contents
- About this manual
- Introducing the Drystar 5500
- Basic operation (operator mode)
- Advanced operation (Key-operator mode)
- Overview of Key-operator functions
- Stopping the printing process
- Viewing printer information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Performing the calibration procedures
- Installation
- Quality control for general radiography applications (DT 2 B & DT 2 C)
- Quality control for mammography application (DT 2 Mammo) (optional)
- Controlling the Drystar 5500 via a remote PC (with browser)
- System description
- Preventive maintenance and replacements
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Remarks for HF-emission and immunity
- Remarks for HF-emission and immunity
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in an electromagnetic environment in which the radiated high frequency disturbance variabl...
- Remarks for HF-emission and immunity
- Index
125
2900H EN 20071108 Advanced operation (Key-operator mode)
DRYSTAR 5500/5503 REFERENCE MANUAL
14 When the contents of the floppy is copied onto the hard disk, the following
message asks you to insert the next floppy (if a next one is required):
15 Remove the floppy disk and insert the next floppy disk (‘disk x/y’) when
necessary. Press the Confirm key to continue.
The printer will copy the new software data onto the hard disk.
16 Repeat steps 14 and 15 until all floppy disks have been copied onto the
hard disk.
When all the files have been copied from the last floppy disk, the following screen is
displayed:
17 Remove the last floppy disk and press the Confirm key.
In case the software requires a reset, the following screen will be displayed:
18 Press the Confirm key to reset the printer.
In case the software requires no reset, the following screen will be displayed:
Disk x/y
Print head data
A:/<path><filename>
D:/<path><filename>