User Manual
Table Of Contents
- Table of contents
- About this manual
- Introducing the Drystar 5500
- Basic operation (operator mode)
- Advanced operation (Key-operator mode)
- Overview of Key-operator functions
- Stopping the printing process
- Viewing printer information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Performing the calibration procedures
- Installation
- Quality control for general radiography applications (DT 2 B & DT 2 C)
- Quality control for mammography application (DT 2 Mammo) (optional)
- Controlling the Drystar 5500 via a remote PC (with browser)
- System description
- Preventive maintenance and replacements
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Remarks for HF-emission and immunity
- Remarks for HF-emission and immunity
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in an electromagnetic environment in which the radiated high frequency disturbance variabl...
- Remarks for HF-emission and immunity
- Index
110
2900H EN 20071108Advanced operation (Key-operator mode)
DRYSTAR 5500/5503 REFERENCE MANUAL
Restoring printer settings from the hard disk
1 Perform steps 1 to 2 of the ‘Accessing the restore configuration menu’ procedure
on page 107 to select the ‘Restore Configuration’ screen:
2 Press the Up/Down arrow keys in the ‘Restore configuration’ screen to select the
required printer settings from the hard disk, followed by the Confirm key.
The following screen is displayed.
If you want to restore the configuration on the back-up floppy, select ‘yes’ and press
the Confirm key. The printer will now enter the ‘Saving the current configuration’
(refer to page 105).
If you only want to restore the configuration on the printer hard disk, select ‘no’ and
press the Confirm key.
After the restore operation, the following screen is displayed.
Press the Confirm key to reset the printer. After the reset, the new settings will be
active.
Press the Escape key to quit the application. The old settings will remain active until
the next reset.
2 Settings 10/05/04 10:55
3 Settings 08/05/04 08:05
4 Settings 08/05/04 07:45
5 Settings 08/05/04 07:31