User Manual
Table Of Contents
- Table of contents
- About this manual
- Introducing the Drystar 5500
- Basic operation (operator mode)
- Advanced operation (Key-operator mode)
- Overview of Key-operator functions
- Stopping the printing process
- Viewing printer information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Performing the calibration procedures
- Installation
- Quality control for general radiography applications (DT 2 B & DT 2 C)
- Quality control for mammography application (DT 2 Mammo) (optional)
- Controlling the Drystar 5500 via a remote PC (with browser)
- System description
- Preventive maintenance and replacements
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Remarks for HF-emission and immunity
- Remarks for HF-emission and immunity
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in an electromagnetic environment in which the radiated high frequency disturbance variabl...
- Remarks for HF-emission and immunity
- Index
107
2900H EN 20071108 Advanced operation (Key-operator mode)
DRYSTAR 5500/5503 REFERENCE MANUAL
Restoring the configuration settings
When necessary, you can restore the configuration settings of the printer from
a previously made back-up copy.
The following functions are provided for restoring a back-up copy of the
configuration files:
• ‘Restoring printer settings from the back-up floppy disk’ (page 108).
• ‘Restoring printer settings from the hard disk’ (page 110).
Accessing the restore configuration menu
1 Press the Key-operator key to enter the Key-operator mode.
2 On the Key-operator main menu, press the Down key five times, followed by the
Confirm key to select ‘Restore configuration’.
The ‘Restore configuration’ screen is displayed:
3 Press the Escape key to return to the Key-operator main menu.
4 Press the Escape key to quit the Key-operator mode.
This menu is the starting point for restoring printer settings (see below).
2 Settings 10/05/04 10:55
3 Settings 08/05/04 08:05
4 Settings 08/05/04 07:45
5 Settings 08/05/04 07:31