User Manual
Table Of Contents
- Table of contents
- About this manual
- Introducing the Drystar 5500
- Basic operation (operator mode)
- Advanced operation (Key-operator mode)
- Overview of Key-operator functions
- Stopping the printing process
- Viewing printer information
- Changing the configuration settings
- Printing images
- Saving the configuration settings
- Restoring the configuration settings
- Performing the calibration procedures
- Installation
- Quality control for general radiography applications (DT 2 B & DT 2 C)
- Quality control for mammography application (DT 2 Mammo) (optional)
- Controlling the Drystar 5500 via a remote PC (with browser)
- System description
- Preventive maintenance and replacements
- Troubleshooting
- Equipment information sheet
- Drystar media density response data
- Quality Control Charts
- Remarks for HF-emission and immunity
- Remarks for HF-emission and immunity
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in the electromagnetic environment given below. The user of the device should ensure that it is used in such an environment.
- This device is intended for operation in an electromagnetic environment in which the radiated high frequency disturbance variabl...
- Remarks for HF-emission and immunity
- Index
101
2900H EN 20071108 Advanced operation (Key-operator mode)
DRYSTAR 5500/5503 REFERENCE MANUAL
Printing test images from the hard disk
Test images are useful for checking the print quality. The Drystar 5500 offers
a number of built-in test images stored on the hard disk.
1 Perform steps 1 to 2 of the ‘Accessing the Print images menu’ procedure on
page 100 to select the ‘Print image’ screen.
2 On the ‘Print image’ menu, press the Confirm key to select ‘Test image’.
The ‘Select test image’ screen is displayed:
3 Press the Up/Down arrow keys to select the desired test image, followed by the
Confirm key.
4 Define the input tray for printing.
The ‘Select input tray’ screen is displayed:
5 Press the Up/Down arrow keys to select the desired input tray, followed by the
Confirm key.
The ‘Number of copies’ screen is displayed:
6 Press the arrow keys to increment/decrement the number. Press the Left/Right
arrow keys to move through the field.
For more info, refer to ‘Data entry’ on page 33.
1 smpte_lin.tif
2 smpte_1300.tif
3 smpte_kan.tif
4 Artefac_5500.tif
5 TG18QC.tif