User Manual

Confidential Page 2 of 3 06/07/2011

F:\agbmi05\Personal\PCBs\HE\Cirrus\CirrusRFIDreaderFCC\CirrusRFIDreaderRegulatoryInetgrationInstr

uctions.doc

Medical Imaging

RDE

FCC Regulatory requirements

When integrating the reader (A800626) into an application the user should respect the

following regulatory requirements – taken from Code of Fedural Regulations April

, 2011, part 15 subpart C (intentional radiators) paragraph 15.212 (A):

If using a permanently affixed label, the modular transmitter must be labeled with its own FCC

identification number, and, if the FCC identification number is not visible when the module is installed

inside another device, then the outside of the device into which the module is installed must also display a

label referring to the enclosed module. This exterior label can use wording such as the following:

“Contains Transmitter Module FCC ID: XYZMODEL1” or “Contains FCC ID: XYZMODEL1.” Any similar

wording that expresses the same meaning may be used. The Grantee may either provide such a label, an

example of which must be included in the application for equipment authorization, or, must provide

adequate instructions along with the module which explain this requirement. In the latter case, a copy of

these instructions must be included in the application for equipment authorization.

As the reader has a permanent affixed label (with the text “FCC ID: HPL5243”) and,

because the module is not visible from the outside, an external label is required that

has the text “Contains Transmitter Module FCC ID: HPL5243” or “Contains FCC ID:

HPL5243.”

This text could be integrated into the identification plate of the host application.

Additional regulatory information

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1)

This device may not cause harmful interference, and

(2)

This device must accept any interference received, including interference that

may cause undesired operation.