User Guide

WaveACCESS Surge Arrester
A-6 Outdoor Antenna Installation Guide
WaveACCESS Surge Arrester 1
The ”WaveACCESS Surge Arrester” (sometimes also referred to
as “Lightning Protector”) can protect your sensitive WaveACCESS
equipment from high-voltage currents caused by discharge and
transients at the antennas.
Figure A-1 Mounting the WaveACCESS Surge Arrester
To mount the WaveACCESS Surge Arrester:
1. Determine a suitable location for the bracket (item B) as
described in Chapter 2 “Preparing for Installation”.
2. Use the screws (item C) to attach the bracket the wall.
3. Apply a ring-terminal to the ground wire, and use the bolt, lock-
washer and nut (item D) to connect the ground-wire (item E) to
the mounting bracket.