User Guide
Table Of Contents
- Table of Contents
- WaveLAN Technical Support
- Regulatory Information
- Welcome
- Preparing for Installation
- Determine Range & Clearance
- Installing the Antenna
- The Antenna Cabling System
- 14 dBi Directional Antenna
- 7 dBi Omni-Directional Antenna
- Index
- List of Figures
- List of Tables
- Warranty Repair Card
Mounting the Antenna
4-8 Outdoor Antenna Installation Guide
Mounting on a Flat Surface 4
For mounting the antenna to a flat vertical surface, you must
provide a smooth surface for the antenna mount. On wall surfaces
such as brick, block or stucco, use an intermediate surface such as
a plywood board or metal plate between the wall and antenna. The
intermediate surface will need to be of sufficient strength to prevent
distortion of the antenna base when the mounting hardware is
tightened.
To mount the antenna proceed as follows:
1. Verify if you have all the items listed below:
■ The WaveACCESS 2.4 GHz antenna
■ (optional) an intermediate plate
■ 4 plugs and screws
■ 4 flatwashers
■ An electric drill
■ A screwdriver to tighten the screws
Figure 4-2 Mounting the 14 dBi Antenna to a Wall