User Guide
Table Of Contents
- Table of Contents
- WaveLAN Technical Support
- Regulatory Information
- Welcome
- Preparing for Installation
- Determine Range & Clearance
- Installing the Antenna
- The Antenna Cabling System
- 14 dBi Directional Antenna
- 7 dBi Omni-Directional Antenna
- Index
- List of Figures
- List of Tables
- Warranty Repair Card
Overview of the Indoor Installation
Outdoor Antenna Installation Guide 2-3
Overview of the Indoor Installation 2
To setup a point-to-point wireless connection, you will need:
■ Two WaveACCESS Office Router Kits, and
■ Two Low-loss antenna cables.
Figure 2-1 shows an overview of the hardware setup for the indoor
installation.
Figure 2-1 Overview Indoor Installation
On each end of the wireless link you will need:
A. A WaveACCESS IEEE adapter card (see “Selecting the Right
WaveACCESS Card” on page 2-4).
B. A WavePOINT-II device that has been loaded with
WaveACCESS Office Router Router software.
C. The Cable Assembly to connect the WaveACCESS IEEE
adapter card (A) to the Surge Arrester.
D. A surge arrester to protect your sensitive WaveACCESS
equipment from static discharge and transients that may occur
to your antenna.
E. A low-loss antenna cable to connect the indoor installation to
the outdoor antenna.