User's Manual

24 dBi Directional Parabolic Grid Antenna
Hardware Specifications
F-4 ORiNOCO Outdoor Antenna Installation Guide
5. Insert two carriage bolts from the front to attach.
Figure F-3 Attach the mounting Bracket
6. Secure on the back with the lock washers and nuts as pictured in
Figure F-3).
7. Re-check the dipole feed assembly for the proper polarity.
8. Attach the feed on the front with 2 carriage bolts. Secure on the back with the
lock washers and nuts.
Mounting the Antenna
!
DANGER:
Installation of antenna near power lines is dangerous! Before you
proceed, make sure you have read and understood the safety
precautions as described in Chapter 2 “Preparing for Installation”.
1. Before climbing the roof, make sure you have:
■ The assembled antenna
■ The U-bolts and mast clamps to mount the grid antenna to the mast.
2. Determine the desired alignment of the antenna:
■ For horizontal alignment you will need both U-bolts and the 4 lock
washers and nuts.
■ For tilted alignment, you will only use a single U-bolt and two lock
washers and nuts. This mounting method allows you to mount the
antenna with an elevation in 10
0
degree increments