User's Manual
Table Of Contents
- Welcome
- Preparing for Installation
- Determine Range & Clearance
- Installing the Antenna
- The Antenna Cabling System
- 14 dBi Directional Antenna
- 7 dBi Omni-Directional Base Station Antenna
- 10 dBi Omni-Directional Base Station Antenna
- 12 dBi Directional Wide Angle Antenna
- 24 dBi Directional Parabolic Grid Antenna
- Certified Outdoor Solutions
- Support & Warranty
- Index
- List of Figures
- List of Tables
12 dBi Directional Wide Angle Antenna
Hardware Specifications
E-2 ORiNOCO Outdoor Antenna Installation Guide
Figure E-1 Mounting the 12 dBi Wide Angle Antenna
2. Assemble the angle adjustment brackets to the upper mounting bracket with
1/2” bolts, lock washers, flat washers and nuts.
3. Next assemble the angle adjustment brackets and lower mounting brackets
to the antenna base plate with 1/2” bolts, lock washers, and nuts.
This adjustment is for 0 degree mounting.
To adjust from 0 to -20 degrees, loosen the hardware at both ends of the
angle adjustment bracket and slide it in the slot to the preferred angle.
4. Tighten hardware securely. The U-bolts should be tightened to 9 Nm (7 ft.-
lbs).
5. Proceed with “Connecting the Antenna Cable” on page 4-6 to connect the
antenna to the indoor equipment and seal the antenna connectors.