User's Manual
Table Of Contents
- Welcome
- Preparing for Installation
- Determine Range & Clearance
- Installing the Antenna
- The Antenna Cabling System
- 14 dBi Directional Antenna
- 7 dBi Omni-Directional Base Station Antenna
- 10 dBi Omni-Directional Base Station Antenna
- 12 dBi Directional Wide Angle Antenna
- 24 dBi Directional Parabolic Grid Antenna
- Certified Outdoor Solutions
- Support & Warranty
- Index
- List of Figures
- List of Tables
7 dBi Omni-Directional Base Station
Antenna
Hardware Specifications
C-2 ORiNOCO Outdoor Antenna Installation Guide
4. Use the lock-washers (item E) and nuts (item F) to secure the bracket to the
mast.
Use a wrench to tighten the nuts and ensure the bracket will be fixed to the
top of the mast.
5. Next feed the antenna cable of the 7 dBi omni-directional Base Station
antenna (item A) through the hole of the mounting bracket.
6. Slide the antenna down, until its metal base is enclosed by the mounting
bracket as pictured in Figure C-1.
Figure C-1 Mounting the 7 dBi Antenna to a Mast
7. Use a wrench to tighten the bracket bolt (item G) to fix the antenna into its
position.
!
CAUTION:
Avoid overtightening the hose-clip nut to avoid damage to the clip and
your antenna.
8. Proceed with “Connecting the Antenna Cable” on page 4-6 to connect the
antenna to the indoor equipment and seal the antenna connectors.