User's Manual

The Antenna Cabling System
The Outdoor Cabling Components
A-2 ORiNOCO Outdoor Antenna Installation Guide
To connect your Outdoor Router hardware to an outdoor antenna installation you
will need the following cabling components as pictured on the right side of this
page:
a. The ORiNOCO Cable Assembly
b. The ORiNOCO Surge Arrester
c. A Low-Loss Antenna Cable
d. One of the outdoor antennas described in Appendices B through F.
When purchasing new ORiNOCO Outdoor Router products, each of the
components listed above will be equipped with Standard N-Type connectors.
When ordering separate components, for example as a spare part or
replacement to previously purchased Lucent ORiNOCO outdoor antenna
equipment carefully read the note on the following page to ensure that you
order components with an N-Type connector that matches the other parts of
your Outdoor Antenna Cabling System.
Selecting the Correct Connector-Type
All cabling components of the ORiNOCO Outdoor Antenna system come with
Standard-N type connectors as pictured in Table A-1 below.