User Manual

Exposure to Radio Frequency Radiation
SAR (Specific Absorption Rate) compliance has been established and found
to comply in accordance with FCC OET Bulletin 65 and guidelines of IEEE
C95.1-1995.
Caution:
! To comply with the FCC RF Exposure compliance requirements, the
user is advised to maintain a distance of at least 13 mm from the
antenna of the device while in use
Federal Communications Commission Notice
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy. If not
installed and used in accordance with the instructions, it may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning off and on, the user is encouraged to try and
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the distance between the equipment and the receiver
• Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.
The FCC requires the user to be notified that any changes or modifications to this
device that are not expressly approved by Agere may void the user’s authority to
operate the equipment.