Installation Sheet

For assistance, call 1-800-522-7336 Mon–Fri 7:00 AM – 4:00 PM MT

or visit www.AgelessIronHardware.com/support

INSTALL TRACK PROTECTORS

FLOOR GUIDE INSTALLATION

1. Drill a 1/8” pilot hole 3” in from the

roller strap on both sides.

2. Install track protectors with

provided screws.

3. Do NOT fully tighten screws.

4. Rotate track protectors so they protrude

from the door-face. Track protectors

are eccentric and will be rotated to

the correct position after the door is

mounted on the track.

1. The oor guide is mounted to the oor at the bottom of the door, and prevents the door

from swinging in or out.

2. For proper operation, a 1/4” wide slot should be present 1” deep into the bottom of the

door.

3. Simply place the oor guide against the wall behind the door, mark the holes and drill

the holes with a 1/4” bit. Note the oor guide should be positioned so that it engages the

door when open and closed. Install the plastic anchors into the oor, and mount the oor

guide using the provided screws.

4. If your door does not have the slot, the oor guide can be utilized to prevent the door from swinging out

(only).

5. Simply place the oor guide against the outside of the door, mark the holes and drill holes with a 1/4” bit.

6. Install the plastic anchors into the oor, and mount the oor guide using the provided screws.

PK315BD