Installation Sheet
For assistance, call 1-800-522-7336 Mon–Fri 7:00 AM – 4:00 PM MT
or visit www.AgelessIronHardware.com/support
2
TRACK INSTALLATION MEASUREMENTS
1. Measure the height of the door. Add 1¾” to this measurement. This is the height of the centerline of
the door track. Example: 84” door + 1 ¾” = 85¾” track centerline.
2. Mark 2-3” of the track centerline with a pencil approx. 3” outside the jamb or opening.
3. Measure out 3” from the inside of the door jamb or opening. Lightly draw a line vertically from this
point to where it intersects the track centerline. This is the location for the rst track mounting hole.
4. Drill a 1/4” hole for the rst track mounting hole. Erase any pencil marks.
5. Mount one end of the track using the spacer between the wall and track, and the provided screw
and TMS Washer. Do not fully tighten.
6. Raise the track until it is level. Use a level to check. Mark the other four mounting holes.
7. Drill the remaining four mounting holes with a 1/4” drill. Note that any holes not in wood will need to
be enlarged to accept the 3/8” x 2” plastic wall anchors. Raise the track, and install the remaining
screws and TMS washers. Do not fully tighten.
8. Using a level, raise the track until it is level, and fully tighten all ve screws.
4”
3.0”
0.5”
DOOR HEIGHT
DOOR HEIGHT PLUS 1.75”
17.75” 17.75” 17.75”
78.75”
17.75”
Weight
Capacity
300 lbs
Track will t doors
1
3/8
” to 1
3/4
” thick,
28” to 36” wide.
NOTE: You door should
overlap both sides and
top of the opening by
approx. 1”.
PK315BD