Installation Sheet

FLUSH PULL & GRIP COMBINATION

1. Determine where you want the grip to be on the door horizontally. If there is a vertical stile (board that

goes from the top of the door to the bottom, on the door edge [see image at the bottom of page 2]),

normal placement is in the middle of this board. For example: If the style is 4.5” wide, the center of the

grip would be located in the middle, or 2.25” from the edge. If the door has no visible stiles, locate the

grip 2.5” from the door edge. Mark this distance lightly with a pencil.

2. Determine where you want the grip to be on the door vertically. Normal placement is 33” from the

bottom of the door to the bottom mounting hole, or whatever is appropriate for the door.

3. Use the included template to mark the mounting holes. Double check that these holes are the exact

same distance from the edge of the door. Drill through the door with a 3/8” diameter bit at the marked

locations.

4. Follow steps 4 and 5 on page 1.

5. Push the provided screws though the ush pull and door, and thread into the grip. Tighten securely.

DOOR

RECESSED AREA

OF PULL ON

BACK SIDE

PK315BD

For assistance, call 1-800-522-7336 Mon–Fri, 7:00 AM–4

:00 PM MT

or visit www.AgelessIronHardware.com/support