Installation Sheet

BARN DOOR GRIP ONLY

1. Determine where you want the grip to be on the door horizontally. If there is a vertical stile (board that

goes from the top of the door to the bottom, on the door edge), normal placement is in the middle of

this board. For example: If the style is 4.5” wide, the center of the grip would be located in the middle,

or 2.25” from the edge. If the door has no visible stiles, locate the grip 2.5” from the door edge. Mark

this distance lightly with a pencil.

2. Determine where you want the grip to be on the door vertically. Normal placement is 33” from the

bottom of the door to the bottom mounting hole, or whatever is appropriate for the door.

3. Use the included template to mark the mounting holes. Double check that these holes are the exact

same distance from the edge of the door. Drill through the door with a 3/8” diameter bit at the marked

locations.

4. Countersink the holes on the inside of the door 1/8” deep with a 9/16” drill. This will allow the screws to

sit ush on the door.

5. Push the provided screws though the door, and thread onto the grip. Tighten securely.

8”

DOOR STILE

GRIP

PK315BD

For assistance, call 1-800-522-7336 Mon–Fri, 7:00 AM–4

:00 PM MT

or visit www.AgelessIronHardware.com/support