Installation Sheet

ManualsBrandsAgeless Iron ManualsHardwareRustic Black Cast Iron 8" Inch Center to Center Single Sliding Barn Door Recessed Flush Pull

FLUSH PULL ONLY

1. Determine where you want the pull to be on the door horizontally. If there is a vertical stile (board that

goes from the top of the door to the bottom, on the door edge [see drawing at the bottom of page 2]),

normal placement is in the middle of this board. For example: If the style is 4.5” wide, the center of the

grip would be located in the middle, or 2.25” from the edge. If the door has no visible stiles, locate the

grip 2.5” from the door edge. Mark this distance lightly with a pencil.

2. Determine where you want the pull to be on the door vertically. Normal placement is 33” from the

bottom of the door to the bottom mounting hole, or whatever is appropriate for the door.

3. Use the attached template and mark the mounting holes. Double check that these holes are the exact

same distance from the edge of the door. Drill into the door 1” with a 3/16” diameter bit at the marked

locations.

4. Hold the pull on the door, with the holes aligned, and trace around the recessed area of the pull

(part that will t into the door). Then, using a router, remove this area 1/2” deep to make room for the

recessed area of the pull. If a router is not available, a chisel can be used. Refer to the video for more

details.

5. Check that the pull sits ush on the door, and does not “rock” when opposite corners are pushed.

6. Install provided wood screws and tighten securely.

RECESSED AREA OF PULL

ON BACK SIDE

8”

BARN DOOR HARDWARE INSTALLATION:

BARN DOOR FLUSH PULL/GRIP

PK315BD

For assistance, call 1-800-522-7336 Mon–Fri, 7:00 AM–4:00 PM MT

or visit www.AgelessIronHardware.com/support

Summary of content (3 pages)

PAGE 1
BARN DOOR HARDWARE INSTALLATION: BARN DOOR FLUSH PULL/GRIP FLUSH PULL ONLY 1. Determine where you want the pull to be on the door horizontally. If there is a vertical stile (board that goes from the top of the door to the bottom, on the door edge [see drawing at the bottom of page 2]), normal placement is in the middle of this board. For example: If the style is 4.5” wide, the center of the grip would be located in the middle, or 2.25” from the edge. If the door has no visible stiles, locate the grip 2.
PAGE 2
BARN DOOR GRIP ONLY 1. Determine where you want the grip to be on the door horizontally. If there is a vertical stile (board that goes from the top of the door to the bottom, on the door edge), normal placement is in the middle of this board. For example: If the style is 4.5” wide, the center of the grip would be located in the middle, or 2.25” from the edge. If the door has no visible stiles, locate the grip 2.5” from the door edge. Mark this distance lightly with a pencil. 2.
PAGE 3
FLUSH PULL & GRIP COMBINATION 1. Determine where you want the grip to be on the door horizontally. If there is a vertical stile (board that goes from the top of the door to the bottom, on the door edge [see image at the bottom of page 2]), normal placement is in the middle of this board. For example: If the style is 4.5” wide, the center of the grip would be located in the middle, or 2.25” from the edge. If the door has no visible stiles, locate the grip 2.5” from the door edge.