Data Sheet

RFbeam Microwave GmbH
Datasheet
AGD-T7813-125 (MC-133)
© RFbeam Microwave GmbH www.rfbeam.ch
Page 5/6
Integrators Information
United States (FCC)
This module has been granted modular approval for fixed and/or mobile applications. The modular
approval allows the end user to integrate the module into a finished product without obtaining
subsequent and separate FCC approvals for intentional radiation, provided no changes or
modifications are made to the module circuitry. Changes or modifications could void the user’s
authority to operate the equipment. The end user must comply with all of the instructions provided by
the Grantee, which indicate installation and/or operating conditions necessary for compliance. The
finished product is required to comply with all applicable FCC equipment authorizations regulations,
requirements and equipment functions not associated with the transmitter module portion.
Note
Modification to this product will void the users’ authority to operate this equipment.
Warning
The OEM integrator is responsible for the final compliance of the end product with this integrated
modular approved transmitter module. This includes measurements with the RF module integrated
and activated as defined in KDB 996369 and if applicable appropriate equipment authorizations as
defined in §15.101.
Labelling and user information requirements
If the label of the module is not visible from the outside of the end product, it must include the following
texts on the label of the host product:
FCC: Contains FCC ID: WH3-MC-133-2
In addition to marking the product with the appropriate ID’s, the end product shall bear the following
statement in a conspicuous location on the label or alternatively in the user manual:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
RF Exposure
This module is approved for installation into fixed and/or mobile host platforms and must not be co-
located or operating in conjunction with any other antenna or transmitter except in accordance with
FCC multi-transmitter guidelines. End users must be provided with transmitter operating conditions for
satisfying RF Exposure compliance.