Data Sheet

RFbeam Microwave GmbH
Datasheet
AGD-T7813-125 (MC-133)
© RFbeam Microwave GmbH www.rfbeam.ch
Page 4/6
Connector Pinout
On module side a Samtec HW-04-15-F-D-325-SM connector with the following pinout is used:
1: /Enable Enable/Disable RF-part. Connect to 0V for normal operation
2: +3.3V Power Supply. Connect to +3.3V (3.15V .. 6.0V)
3: GND Ground connection. Connect to 0V
4: Q Out Analog Output Q-Channel
5: I Out Analog Output I-Channel
6: VCO Frequency control input. A voltage between 1..5V adjusts
TX Frequency by 0 .. 50MHz. Can be used for FSK or FMCW
7: S&H Sample&Hold Switch Analog Output. Leave it open or connect
to +3.3V for normal operation
8: Temp Temperature Sensor output of LMT84 temperature sensor
Mechanical Drawing