Product Manual

28
IMPORTANT
SAFETY PRECAUTIONS
All work must be performed in accordance with company working practices, in-line with adequate risk
assessments. Only skilled and instructed persons should carry out work with the product. Experience and safety
procedures in the following areas may be relevant:
• Working with mains power
• Working with modern electronic/electrical equipment
• Working at height
• Working at the roadside or highways
1. This product is compliant to the Restriction of Hazardous Substances (RoHS - European Union directive
2011/65/EU).
2. Should the product feature user-accessible switches, an access port will be provided. Only the specified
access port should be used to access switches. Only non-conductive tools are to be used when operating
switches.
3. The product must be correctly connected to the specified power supply. All connections must be made
whilst the power supply is off or suitably isolated. Safety must take always take precedence and power
must only be applied when deemed safe to do so.
4. No user-maintainable parts are contained within the product. Removing or opening the outer casing is
deemed dangerous and will void all warranties.
5. Under no circumstances should a product suspected of damage be powered on. Internal damage may
be suggested by unusual behaviour, an unusual odour or damage to the outer casing. Please contact
AGD for further advice.
6. This device complies with part 15 of the FCC Rules and contains licence-exempt transmitter(s)/receiver(s)
that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s) .
• Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, includi
ng interference that may cause undesired operation.
7
. A separation distance of at least 20 centimetres should normally be maintained between this product
and the body of users or nearby persons.
Changes or modifications not expressly approved by AGD Systems Ltd could void the user’s autho
rity to operate
the equipment.
L
e présent appareil est conforme aux CNR d’ISDE Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2)
l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.