User's Manual

19
RADAR COMMANDS
RADAR COMMAND OVERVIEW
Commands are used to control the operation of radar. These can be sent over the RS422 UART Link.
(Ethernet available at a later date)
Commands are immediately followed by an operator that indicates the required action. Not all the operators
are supported for all commands. Where an operator is used and it is not supported the radar will respond with
warning message. The table shows the commands used by the radar.
Operator Operation
= Set a parameter to a value e.g. *LS=50<CR>
? Respond with value or values
^ Set default value for parameter
$ Provide help on the command
! Do something e.g. *REBOOT! Reboots the radar