User manual

[e-mail] Page | 29 1-800-930-0949
Figure 6.1 – An example of 4 cameras set up using Multi-Device Settings
6.5 – Basic Network Settings
If you would like to set a static IP for the camera (highly recommended), you can do so in the Basic
Network Settings page. Keep the camera in the same subnet of your router or computer. Our subnet in
this example is “192.168.1.”
You will notice that most of these settings are exactly the same as the settings seen in the IP Camera
Tool software. You can use this method of changing the network information as an alternative to using IP
Camera Tool if you would like.
If you are unsure of your subnet mask, gateway, or DNS server, you can always check by using the
methods explained in Section 5.1 of this manual.