Specifications
Heat-Clean Enamel
l Fan Oven – Back panel only
This special enamel has a continous cleaning action, which works best if a pattern of low
and high temperature cooking is followed. By using low temperature roasting, excessive fat
splashes can be avoided. Should any excessive staining occur, immediately clean the area
with hot water containing detergent, and a nylon washing-up brush. Resistant stains require
the oven to be run at 210ºC for 2 hours.
Do not use any cleaning material which may clog the pores of the special coating
e.g. pastes and powders, soap-filled pads, wire wool, spray cleaners, brush-on
cleaners, caustic solutions, metal scrapers/knives, and prevent the continuous
cleaning action.
Door Liners
l May be cleaned with a cream cleaner or soap impregnated pad.
l DO NOT, however, immerse the doors in water as they are packed with insulating
material which will be damaged by excessive moisture.
Controls
l The enamelled surfaces under the knobs can be treated as in the section ‘Door Liners’.
Avoid the use of excessive water.
l DO NOT use oven cleaners, scouring pads and abrasive powder for cleaning plastic
knobs. A wipe with a damp cloth should be sufficient.
Important Note:
AGA recommend Vitreous Enamel Association approved cleaners for cleaning the
vitreous enamel surfaces of this product.
15