Installation Guide

8
Installation
CAUTION
Shelves must be removed prior to moving the
refrigerator.
Air Seal
Air Seal
Your refrigerator includes glass shelves that are
designed to catch and hold accidental spills.
You can easily adjust shelf positions in the fresh food
compartments to suit your needs. The shelves have
mounting brackets that attach to slotted supports at the
rear of each compartment.
To change the position of a shelf:
1. Before adjusting a shelf, remove all food.
2. Lift the front edge up and pull the shelf out.
3. Replace by inserting the mounting bracket hooks into the
desired support slots.
4. Lower the shelf and lock into position.
CAUTION
To avoid injury from breakage, handle tempered
glass shelves carefully.
NOTE
Features may vary according to model.
Shelf features (Select Models)
or
Full Custom-Design
TM
Shelf
Reposition the Air Seal
(Slide-out Shelves)
1. Remove air seal by pushing down on the  ap with a
downward rotation.
2. Position the air seal towards the outside end of the shelf to
avoid the air tower when shelf is pushed back into place.
3. Install seal by sliding lower tab of seal up into bottom rear
slot of shelf with seal at a downward angle then pulling up
on seal  ap until seal sits snug on back of shelf and  ap sits
at about a 10 degree angle from shelf surface.
Reposition the Air Seal
(Channel in rear)
1. Remove air seal by pushing seal straight back.
2. Position the air seal towards the outside edge of the shelf to
avoid the air tower when shelf is pushed back into place.
3. Install seal by sliding the open channel end of the seal onto
back edge of shelf until seal sits snug on back of shelf and
 ap sits at about a 10 degree angle from shelf surface.