User`s manual

Disconnect from the electricity supply before commencing
servicing, particularly before removing any of the
following:- control panel, side panels, hotplate tray or any
electrical components or covers.
Before electrical re-connection, check that the appliance
is electrically safe.
NOTE: References to LH and RH oven apply as viewed
from the front.
A. To Remove Hob
1. Isolate from electric supply.
2. Carefully remove all of the control knobs.
3. Remove 12 fixing screws as shown in diagram.
N.B. The two screws fitted to the underside of the front
facia, which should be removed are in the outer most
position.
4. Lift the rear of the hob and slide forward to clear the
front edge of the chassis.
5. Raise the facia and disconnect the timer plug, as
shown.
6. Lift the hob clear of the elements and remove.
7. Re-assemble in reverse order.
B. To Remove Side Panels
1. Isolate from electric supply.
2. Lower front mobility wheels see section ‘Levelling’
page 27, in the Users instructions.
3. Remove fixing screws and lift off side panel.
4. Re-assemble in reverse order,
C. To Remove Grill/Hob Regulator/Light Switch
1. Isolate from electric supply.
2. Proceed as ‘TO REMOVE HOBPLATE’.
3. Remove the four fixing screws securing the control
mounting panel, see diagram.
4. Remove two screws securing control to control
mounting panel.
5. Withdraw control and cables taking care not to strain
the cables.
6. Disconnect cables from the control.
NOTE: Take care to identify terminations.
7. Re-assemble in reverse order.
D. To Remove Oven Thermostats
1. Isolate from electric supply.
2. Lower front mobility wheels see section ‘Levelling’,
page 27 in the Users instructions.
3. Move appliance forward to gain access to the rear.
Take care not to stretch the power cable.
4. Proceed as ‘TO REMOVE GRILL REGULATOR’.
5. Remove (10) back panel screws.
6. Remove thermostat phial and capillary through back of
cooker, note correct capillary route.
7. Re-assemble in reverse order.
30
SERVICING - WARNING
Disconnect from electricity before servicing. Check appliance is safe when you have finished
Servicing