User`s manual

Electrical Connection

This appliance must be installed by a qualified electrician

to comply with the relevant regulations and also the local

electricity supply company requirements.

WARNING: THIS APPLIANCE MUST BE EARTHED.

NOTE: The cooker must be connected to the correct

electrical supply as stated on the voltage label on the

cooker, through a suitable cooker control unit

incorporating a double pole switch having a contact

separation of at least 3mm in all poles. This cooker must

not be connected to an ordinary domestic power point.

The total electrical load of the appliance is approximately

16.4 kW. The cable size used should be suitable for this

load and comply with all local requirements.

Access to the mains terminal is gained by removing the

electrical terminal cover box on the back panel.

Connect the mains cable to the correct terminals for your

electrical supply type.

Check that the links are correctly fitted and that the

terminal screws are tight. Secure the mains cable using

the cable clamp.

Current Opened Earth Leakage Breakers

Where the installation is protected by a 30-milliamp

sensitivity residual current device (RCD), the combined

use of your cooker and other domestic appliances may

occasionally cause nuisance tripping. In these instances

the cooker circuit may need to be protected by fitting a

100mA device. This work should be carried out by a

qualified electrician.

Hob

Turn on each hob plate element in turn and check that

they heat up. Turn off each element.

Grill

Open the grill compartment door. Turn on the grill control

and check that the grill heats up.

Oven Check

Turn on the ovens and check that they start to heat up.

Turn off the ovens.

Fitting the plinth

Remove the 2 screws along the front bottom edge of the

cooker. Hold the plinth in place and refit the 2 screws.

Customer care

Please inform the user how to operate the cooker and

hand over these instructions.

Thank you

Single Phase

Three Phase