User`s manual

WARNING: THIS APPLIANCE MUST BE EARTHED
This appliance is designed for the voltage stated on the
data plate, which is situated in the right hand lower corner
under the plinth plate.
The Aga Masterchef II Ceramic Hob is supplied from the
manufacturers as a fully tested chassis construction.
Ceramic hob, doors, splashback and handrail are
assembled during installation.
Positioning the Cooker
The diagrams show the minimum recommended distance
from the cooker to nearby surfaces.
The hob surround should be level with, or above, any
adjacent work surface. Above hob level, a gap of 60mm
should be left between each side of the cooker and any
adjacent vertical surfaces.
For non-combustible surfaces (such as unpainted metal or
ceramic tiles) this can be reduced to 25mm.
A minimum space of 650mm is required between the top
of the hob and a horizontal combustible surface.
Any cooker hood should be installed in accordance with
the hood manufacturers instructions.
Surfaces of furniture and walls at the sides and rear of the
appliance should be heat, splash and steam resistant.
Certain types of vinyl or laminate kitchen furniture are
particularly prone to heat damage and discolouration. We
cannot accept responsibility for damage caused by normal
use of the cooker to any material that de-laminates or
discolours at temperatures less than 65ºC above room
temperature.
For safety reasons curtains must not be fitted immediately
behind the cooker.
We recommend a gap of 1006mm between units to allow
for moving the cooker. Do not box the cooker in, it must be
possible to move the cooker in and out for cleaning and
servicing. The cooker should not be placed on a base.
Unpacking the Cooker
Do not take any packaging off the cooker until it is directly
in front of the place it is to be installed (unless it will not fit
through a door in its outer packaging).
Levelling
The Masterchef is designed to stand on a flat and level
surface; however any unevenness maybe overcome by
adjusting the four mobility wheels, one at each corner of
the base plate. The adjusting screws are accessed by
removing the plinth (two screws).
Fitting instructions for Rear Spacer
The AGA
Masterchef Deluxe
requires two
spacers to be fitted
to the rear of the
appliance
Remove screw and
fix spacers provided
as shown, one per
side.
27
Installation