Troubleshooting guide

14
Electrical Shock Hazard
• Do not use an extension cord with this appliance.
They can be hazardous and cause decient
operation.
• This unit should not, under any circumstances, be
installed to an un-grounded electrical supply.
• Do not remove the grounding prong from the
power cord.
• Do not use an adapter.
• Do not splash or spray water from a hose on
the appliance. Doing so may cause an electrical
shock, which may result in severe injury or death.
!
WARNING
PRE INSTALLATION CONSIDERATIONS
Electrical Requirements:
Provide a 115 volt, 60 cycle, single phase 15 amp, AC re-
ceptacle. It is recommended that a separately fused circuit
(a time delay fuse or circuit breaker is recommended),
serving only this appliance, be provided. Electrical opening
should be placed 78
1
⁄2" (199.4cm) minimum from the oor.
(See Figure 4).
This product is factory equipped with a power supply
cord that has a three-pronged, grounded plug. It must be
plugged into a mating grounding type receptacle in ac-
cordance with the National Electrical Code and applicable
local codes and ordinances. If the circuit does not have a
grounding type receptacle, it is the responsibility and obli-
gation of the customer to provide the proper power supply.
The unit must be installed according to your local building
codes and ordinances.
Plumbing Requirements:
Ice maker water supply line,
1
⁄4" (6.4mm) outside diameter
copper tubing to come up the rear of cut out opening ap-
proximately 78" (198.1cm) off the oor depending on height
adjustment. Tubing should then pass around the right side
of the power module and around the front to the water sole-
noid valve. Please refer to Figure 5.
When installing the water line for the ice maker, be sure
to install a SHUT-OFF VALVE at a convenient location
between the freezer and the supply line. Required water
pressure range is 20 to 120 psi (138 to 827 kPa).
Also recommended is an in-line WATER FILTER between
the freezer and the supply line to prevent sediment from
blocking water ow through the water solenoid valve.
An ideal location for these items is on top of the cabinet,
behind the grill, and to the right of the power module.
Self-piercing water valves and plastic tubing are NOT ap-
proved for water supply to ice maker.
NOTE