User manual

30
Read all instructions before installing or using this appliance.
Installation Instructions
Save these instructions for future reference.
Regulations
Installation of this range must conform with local
codes, or in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA.54,
latest edition.
In Canada, installation must conform with the
current Natural Gas Installation Code, CAN/
CGA-B149.1 or the current Propane Installation
Code, CAN/CGA-B149.2, and with local codes
where applicable.
This range has been design-certifi ed by CSA
International according to ANSI Z21.1, latest
edition and CAN/CGA-22.2 latest edition.
Read the instructions before installing or
using this appliance. This range becomes hot
in use, the cooktop burners produce exhaust
gases. Take safety precautions - see the safety
warnings in the User Guide, which should be
read together with this installation guide.
The range must be electrically grounded in
accordance with local codes or, in the absence
of local codes, in accordance with the National
Electrical Code (ANSI/NFPA 70, latest edition).
In Canada, electrical grounding must be
in accordance with the current CSA C22.1
Canadian Electrical Code Part 1 and/or local
codes. See ‘Electrical Connection’ in this section
Important
• Observe all governing codes and ordinances.
• The range must be properly grounded.
• Save these instructions for the local electrical
inspector's use.
For Your Safety
Do not store or use combustible materials,
gasoline or other fl ammable vapors and liquids
in the vicinity of this or any other appliance.
If you smell gas
• Open windows.
• Don't touch electrical switches.
• Extinguish any open fl ame.
• Immediately call your gas supplier
Tools
You will need the following tools
1. Electric drill
2. Masonry drill bit & anchors (only required if
fi tting the range on a stone or concrete fl oor)
3. Steel tape measure
4. Phillips head screwdriver
5. Flat head screwdriver
6. 4mm & 3mm Allen keys
7. Spirit level
8. Pencil
9. Open-end or adjustable wrench
10. Pencil and ruler
11. Pipe wrenches
Materials
Additional materials you may need:
• Gas line shut-off valve
• Pipe joint sealant or UL-approved pipe thread
tape with Tefl on* that resists action of natural
and LP gases. *Tefl on: Registered trademark
of DuPont
• Flexible metal appliance connector (1/2’’ I.D.).
A 5-foot length is recommended for ease of
installation but other lengths are acceptable.
Never use an old connector when installing a
new range.
• Flare union adapter for connection to gas
supply line (3/4’’ or 1/2’’ NPT x 1/2’’ I.D.)
• Flare union adapter for connection to pressure
regulator on range (1/2’’ NPT x 1/2’’ I.D.)
• To protect any fl oor covering under the range
a sheet of 1/4’’ thick ply wood or equivalent
large enough to stand the range on