Technical data

TO TEST THE AIMS CONTROL HANDSET

Handset to Base Unit Signal Check/Language Selection

Complete the following procedure to check the handset is communicating with the base unit and

to select a language option.

1. Switch on the power supply to the cooker. Immediately, switch the control knob on the base

unit back and forth between manual and AIMS settings until the blue neon flashes.

2. Immediately after neon starts to flash, press and hold + and - buttons together on the handset

until the blue neon goes out completely (handset display will briefly say ‘SERIAL NUMBER

FOUND’), then release buttons.

3. If the neon does not extinguish completely, but continues to flash with a faint output, then

repeat steps 1 and 2 above.

4. When the connection has been made, the screen will display the language options, use the

+ or - buttons to scroll through the options to the desired language, then press the button

to confirm selection.

5. If the language option needs to be changed at any time then the whole procedure must be

repeated from step 1.

Fig. 11 DESN 515485