Technical data

OVEN THERMOCOUPLE

Fig. 9 DESN 515277 A

NOTE: On AIMS controlled cookers, there is an oven thermocouple

sensor, which is connected to the control PCB (See Fig. 7).

1. Feed the thermocouple sensor and thermostat phial through the guide

tube into the Roasting Oven.

2. Fit the thermocouple sensor to the support plate so that the sensing

tip is as show in Fig. 10. DO NOT OVERTIGHTEN the clamp as this

may damage the sensor. Also, fit thermostat phial through hole in

clamping bracket. Screw support plate to top of roasting oven.

3. When assembling the controls cover to the burner housing:-

Ensure that the thermocouple sensor goes through the notch in the

top of the controls cover, and that the sealed pot is inside the cover

(i.e. sealed pot must not be trapped).

Fig. 10 DESN 515480