Technical data

BURNER ASSEMBLY - AIMS CONTROL

Fig. 8 DESN 515492

SEE FIG. 8

NOTE: Prior to assembly remove controls mounting bracket from burner housing.

1. Fit gas cock to inlet supply pipe.

2. Fit burner assembly to burner housing.

3. Fix AIMS control mounting bracket to burner housing.

4. Fix AIMS control board to mounting bracket.

5. Attach wiring to AIMS control board (See Fig. 7) and solenoid plugs onto solenoids. Fix wires

to cable clamp.

6. WHEN FITTING

AIMS CONTROL COVER:

(a) Take care to route solenoid cables through notch at rear of cover.

(b) The AIMS control knob must pass freely through the clearance hole in the

controls cover. Avoid distorting the control spindle, as this could damage the

PCB. (NOTE: It may be necessary to adjust the fit of the burner housing to front

plate, to fit controls cover correctly).

ASSEMBLY OF BURNER - AIMS CONTROLS

A - ON/OFF CONTROL KNOB

B - TEMPERATURE CONTROL KNOB

C - GAS COCK

D - INLET PRESSURE TEST NIPPLE

E - BURNER PRESSURE TEST

NIPPLE

F - VIEWING WINDOW

G - AIMS CONTROL KNOB

H - SOLENOID N/C (NORMALLY CLOSED

I - SOLENOID N/O (NORMALLY OPEN)