Technical data

7. Check burner pressure as follows:-

Repeat instruction 6 on completely cold cooker with the pressure gauge fitted to the burner

pressure test nipple (E) (See Fig. 7). Check that the burner pressure correctly corresponds

with the table marked ‘TECHNICAL DATA’, (page 7).

NOTE: IF FOR ANY REASON A GAS RATE CHECK IS REQUIRED. TURN OFF ALL OTHER

APPLIANCES USING GAS AND USING THE GAS METER TEST DIAL AND STOPWATCH.

CHECK THAT THE MAXIMUM GAS INPUT TO THE APPLIANCE IS AS INDICATED ON THE

DATA PLATE.

Once the correct setting has been confirmed, the heat control will operate automatically to

maintain the cooker at full temperature.

NOTE: REMEMBER TO NOTE THE SETTING POSITION IF TURNING OFF THE COOKER.

Hand these instructions to the User for retention, and instruct in the safe operation of the

appliance.

Finally advise the User, that for continued efficient and safe operation of the appliance, it is

important that adequate servicing is carried out at regular intervals recommended by the Aga

Specialist or local gas region.

COMMISSIONING (CONTINUED)

INSTRUCTIONS

A - ON/OFF CONTROL KNOB

B - TEMPERATURE CONTROL KNOB

C - GAS COCK

D - INLET PRESSURE TEST NIPPLE

E - BURNER PRESSURE TEST NIPPLE

F - VIEWING WINDOW

FIG. 7

DESN 511191