Technical data

Replacement of parts (Burner)

The only parts to be replaced are:-

Electrodes

Electrode Leads

Control Box

If any other parts fails then the whole burner is to be

replaced.

See Fig. 23

1. Turn off power to appliance.

2. Unscrew the fixing screw and withdraw the

electrodes.

3. Carefully replace the electrodes, ensuring the gasket

is in place. Tighten screw.

See Fig. 24

1. Turn off power to appliance.

2. Unplug 12-way connector.

3. Disconnect ignition lead, earth lead and ionization

lead.

4. Unscrew single fixing screw. Withdraw box.

5. Replace control box fixing screw and wires.

(Electrode Wires - See Page 34 , Fig. 20).

ELECTRODES

CONTROL BOX

FIG. 23

FIG. 24

DESN 512443

DESN 512442