Owner's Manual

Notes

• symbol appears in the top right hand corner of the screen,

if the handset is out of range with the cooker or the

communication/handshake process has not been completed.

When communication is OK then symbol is displayed.

• The button can be used to force communication between

the cooker and the handset. This function is active

once successful initial communication has been made, and

the handset is in range.

This process will be required on the original installation of the AGA Total Control. If the handset is replaced for any reason the new handset

will need to be synchronised.

• You will also need to set the time and date.

• You will also be given the option to set your own Auto program preferences.

Step 1

Handshake can be activated 30 seconds after main power

has been applied to the cooker. The Standby

button on the touch panel must be ‘ON’. It must then be

completed within 2 minutes, otherwise you will need to

repeat the process.

Step 2

Press and hold button on the handset for 10 seconds

to open the communicate/synchronise screen.

The following screen message then appears.

Press and

to synchronise

COMMUNICATION/HANDSHAKE

Step 3

Simultaneously press the and buttons, the serial

number will be ‘found’ by the handset.

The following screen message then appears briefly.

Step 4

Use the and buttons to choose the language you want

the handset text to be in, then press to confirm the

language choice required.

Once time and date has been set the Auto/Event program

screen will appear.

Step 5

Set the correct time and date see Page 12.

Step 6

You have the option to set your own Auto program at this

stage, see Page 13. If you wish to leave until later, then press

it will remain at the pre-set times: 1 Event 7am - 7pm (7 days).

Serial Number

found