Owner's Manual
HANDSET - A HAND HELD CONTROL
Screens
The handset has 3 main screens.
1. The Information Home screen (main menu)
2. The Date/Time screen
3. The Events Programming screen
The display will revert to ‘sleep’ mode after approximately 3
minutes. Simply press the required button to open up any
screen.
The handset displays the time, date and events. Programming is via eight push buttons. The information is displayed via a back-lit LCD
screen.
Button Operations
1. Communication or ‘Handshake’ button
used initially to synchronise the handset to the AGA Total
Control. (On day of installation or in case of replacement handset
2. Clock button
Opens and closes the date and time settings screen.
3. Left/Back Button
Moves back and highlights the previous setting.
4. Plus Button
Increases the highlighted setting.
5. Minus Button
Decreases the highlighted setting.
6. Right/Forward Button
Moves forward and highlights the next setting.
7. Copy Button
copies the time program from the current day to the
following day in the 7-day event calendar screen.
8. 7-day event Button
Opens and closes the 7-day event calendar screen.
HANDSET ADVICE
Operating Distance
The handset will only operate in the same room as the cooker and up
to a maximum distance of 13 feet (4 metres) from the appliance. If
out of recommended operating range, the handset may show
‘Standby’. If this happens move the handset back to within the
recommended distance and it should correct itself, see below.
Handset to AGA Total Control Signal Check
The (Standby) symbol is shown when in the following situations:-
1. In Standby mode
2. If communications fail
3. There is a power cut
4. If the handset is out of range of the AGA Total Control cooker
When transferring information from or to the controller always
operate the handset in front of the cooker, this gives the strongest
signal.
If the handset shows Standby, when the cooker is on,
press the button firmly for 1 second, this will activate
the communication link between the cooker and handset.
Communication/Handshake
For details on initial Communication/Handshake, see Page 11.
Preview Mode
If the handset is out of range of the cooker or if the appliance is
switched off, Preview only mode is available. Changes cannot be
made to the programmed events. The symbol is
displayed in the screen and the message ‘Preview only’ is
displayed briefly when the events program screen is first
entered.
When in Preview Mode you can review the days by using the
and buttons. The and buttons become inactive and you
cannot make any changes.
Handset Failure
In the unlikely event of handset failure, the appliance would still
be operational with the last selected program. The cooker
can also be changed to Manual mode from one of the auto modes
using the mode button on the control panel. If the handset is
damaged or lost, a replacement can be obtained from AGA and
re-programmed to suit your appliance.
D
O NOT PLACE THE HANDSET ON ANY HOT SURFACES.
10
FCC ID: A2M-AGA-TC3
This device complies with part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not
cause harmful interference, and (2) this
device must accept any interference
received, including interference that may
cause undesired operation.
CANADA IC ID No. 10181A-AGATC3
This device complies with the Industry
Canada Radio Apparatus -
Certification Body (CB) Program