Installation Guide

8. Using the stay rod nut adjusting tool, carefully lower the top plate adjusting nuts until the top

plates sits at the required height, making sure that the top sits level and matches the height

of the AGA TC3. (See Fig. 14).

Fig. 14 DESN 516555

9. Slide the complete handrail over the left hand, right hand and centre fixing studs. Once the

assembly has been fitted to the AGA appliance, fit the handrail endcaps (ensuring the

handrail is evenly spaced at each end). The endcaps should be carefully pushed into place

until they sit flush with the outside face of each bracket.

The handrail can now be locked into place using the grub screws on the underside of the

handrail brackets.

Finally fit plinth facia onto magnets positioned on plinth, ensuring the facia sits squarely and

centrally.

Fig. 15 DESN 516569