Dimensions Guide

ManualsBrandsAGA ManualsDouble Oven Dual Fuel RangesAPRO48DFSS

AGA Kitchen Concierge

800-525-5601

#AGAProPower www.aga-ranges.com

aga_professional_48_inch_df_range_spec_sheet_apro48dfss.pdf - pub1/2016 rev 1

INSTALLATION

Check the appliance is electrically safe when you have nished.

Positioning the Range

Fig. 7-1 shows the minimum recommended distances and

clearances from the range to nearby surfaces.

You MUST provide adequate clearances between the range

and adjacent combustible surfaces. These dimensions MUST

be met for safe use of your range.

The location of the electrical outlet and pipe opening (see

Gas Pipe and Electric Outlet Locations) may be adjusted to

meet specic requirements.

A gap of at least 10” (25.4 cm) should be left between each

side of the range and any adjacent vertical surface (Fig. 7-1

dimension ‘A’).

A gap of 2” (5 cm) should be left ABOVE the cooktop level

and any adjacent vertical surface (Fig. 7-1 dimension ‘B’).

The cooktop surround should be level with, or above, any

adjacent work surface.

The maximum depth for cabinets installed above cooktops is

13’’ (33 cm).

The depth of the range is 27 ½’’ (69.8 cm) overall (Fig. 7-2).

Any range hood should be installed in accordance with the

hood manufacturer’s instructions.

Any splashback must be tted in accordance with the

manufacturers instructions. Allowance should be made for the

additional height of the ue trim, which is tted to the cooker

hob.

For safety reasons curtains must not be sited immediately

behind the range.

We recommend a gap of 48” (122 cm) – 48 ½” (123 cm (for

Canada 49” (124.5 cm)) between cupboards to allow for

moving the range.

USA only: If a ush t is required, install the range up to the

cupboard at one side then install the cupboard the other side.

Fitting the Anti-Tip Bracket

n

WARNING: The range must be secured by the anti-

tip bracket supplied. Unless properly installed, the

range could be tipped by leaning on the door. Injury

might result from spilled hot liquids or from the

range itself.

Using the bracket and screws supplied, x the bracket to the

wall (Fig. 7-3). Ensure the stability pin locates beneath the

bracket when the range is in position.

ArtNo.280-0001 36” wide oven dimensions

Min 30” (76.2 cm) / Max 36” (91.4 cm)

between the cooktop

and an extraction hood

Max 13”

(33 cm)

Min 48” (122 cm) - 48½“ (123 cm)

recommended for moving the range.

For Canada, min 49” (124.5 cm)

36” (91.4 cm)

Min 18”

(45.7 cm)

A B

48”

36”

27½”

39¾”

44¼”

Fig. 7-1

Fig. 7-2

Fig. 7-3

Stability pin

Stability bracket

Dimension ‘A’ must be at least 10” (25.4 cm) to any adjacent vertical surface.

Dimension ‘B’ must be at least 2” (5 cm)

to any adjacent vertical surface above the cooktop.

Standard Installation