Use and Care Guide
INSTALLATION
Check the appliance is electrically safe and gas sound when you have nished.
26
Checking the parts:the range, the area that the range will rest on should be built
up with plywood to the same level or higher than the oor
covering.
This will allow the range to be moved for cleaning or
servicing. Also, make sure your oor covering will withstand
180 °F (80 °C); see the ‘Installation Safety Instructions’ section.
Make sure the wall coverings around your range can
withstand the heat generated, up to 200 °F (90 °C), by the
range; see the ‘Installation Safety Instructions’ section.
You will also need the following tools:
1. Electric drill
2. Masonry drill bit & anchors (only required if installing
the range on a stone or concrete oor)
3. Steel tape measure
4. Phillips head screwdriver
5. Flat head screwdriver
6. 2.5 mm Allen key (supplied with the range)
7. Spirit level
8. Open-end or adjustable wrench
9. Pencil and ruler
10. Pipe wrenches
Additional materials you may need:
• Gas line shut-off valve.
• Pipe joint sealant or UL-approved pipe thread tape with
Teflon* that resists action of natural and LP gases.
• Flexible metal appliance connector (½’’ I.D.). A 5foot
length is recommended for ease of installation
but other lengths are acceptable. Never use an old
connector when installing a new range.
• Flare union adapter for connection to gas supply line
(¾’’ or ½’’ NPT x ½’’ I.D.).
• Flare union adapter for connection to pressure regulator
on range (½’’ NPT x ½’’ I.D.).
• To protect any floor covering under the range a sheet of
¼’’ thick plywood or equivalent large enough to stand
the range on.
6 grates Allen key
ArtNo280-0084 DF Pan Supports
1 broiler rack with telescopic
runners
2 at racks with telescopic runners
ArtNo.326-0014 - Cradle rack (Falcon)
2 broiler pans with grids Control knob (°C)
ArtNo.331-0008 - 90SC
grill pan & trivet
Griddle (Optional Extra) Wok cradle (Optional Extra)
2 sets of side supports Toe kick
ArtNo.350-0007 - Plinth USA
2 side panel extensions
Reducer plates for conduit
connection
ArtNo.351-0001 - Side extension
panel USA
ArtNo.020-0012 Reducer Plates USA
Conversion kit from natural gas to
propane gas
Anti-tip device
ArtNo.020-0019
Conversion Kit USA
*Teon: Registered trademark of DuPont