Specification Sheet

AGA Professional 36" Dual Fuel Self-Cleaning
Range
Model # AMPRO36DF
Installation
3
Positioning the Range
The minimum recommended distances and clearances from the
range to nearby surfaces. You MUST provide adequate clearances
between the range and adjacent combustible surfaces. These
dimensions MUST be met for safe use of your range.
The location of the electrical outlet and pipe opening may be
adjustedtomeetspecicrequirements.Agapofatleast3" (7.5
cm) should be left between each side of the range ABOVE the
cooktop level and any adjacent vertical surface.
The cooktop surround should be level with, or above, any
adjacent work surface.
For non-combustible surfaces (such as unpainted metal or ceramic
tiles) the gap each side can be reduced from 3" to 1" (2.5 cm).
A minimum space of 31½" (80 cm) is required between the top of
the cooktop and a horizontal combustible surface. The maximum
depth for cabinets installed above cooktops is 13"’ (33 cm).
The depth of the range is 283/32" (71.36 cm) overall (Fig.7-2).
Any range hood should be installed in accordance with the hood
manufacturer’s instructions. For safety reasons curtains must not
be sited immediately behind the range.
We recommend a gap of 35½" (90 cm) – 36" (91 cm (for Canada
36⅜" (92.5 cm)) between cupboards to allow for moving the
range.
USAonly:Ifaushtisrequired,installtherangeuptothe
cupboard at one side then install the cupboard the other side.
Location of the Range
Do not locate the range where it may be subject to strong drafts.
Anyopeningsintheoororwallbehindtherangeshouldbe
sealed. Make sure the openings around the base of the range that
supply fresh air for combustion and ventilation are not obstructed
by carpeting or woodwork.
Yourrangeisheavyandcansettleintosoftoorcoveringssuch
as cushioned vinyl or carpeting. Use care when moving the range
onthistypeofooring.Itisrecommendedthatthefollowing
instructionsbefollowedtoprotectyouroor.Therangeshould
be installed on a sheet of plywood (or similar material). When the
oorcoveringendsatthefrontoftherange,theareathatthe
range will rest on should be built up with plywood to the same
levelorhigherthantheoorcovering.
Leveling
Place the range in its intended position taking care not to twist it
within the gap between the kitchen units as damage may occur
to the range or the units. Install the oven racks in the oven. Check
forlevelnessbyplacingaleveloracup,partiallylledwithwater,
on one of the oven grids. If using a spirit level, take two readings
withthelevelplaceddiagonallyrstinonedirectionandthenthe
other.
The front feet and rear rollers can be adjusted to level the range
To adjust the height of the rear of the cooker, use a ½" (13 mm)
spanner or socket wrench to turn the adjusting nuts at the front
bottom corners of the cooker. To set the front feet turn the bases
to raise or lower.
Specicationsaresubjecttochangewithoutnotice.Visitwww.aga-ranges.comforthemostup-to-dateinformation.