Use and Care Guide
44
INSTALLATION
Check the appliance is electrically safe when you have nished.
Have your appliance properly installed and grounded by
a qualied technician. The installation must conform with
local codes, or in the absence of local codes, in accordance
with the National Fuel Gas Code, ANSI Z223.1/NFPA 54 or, in
Canada, the Natural Gas and Propane Installation Code, CSA
B149.1 and in addition the National Electrical Code NFPA 70
or the Canadian Electric Code, CSA C22.1.
Electrical requirements
n
For personal safety, DO NOT use an extension cord
with this appliance. Remove the house fuse or open
the circuit breaker before beginning installation.
n
WARNING Electrical Grounding Instructions. This
appliance is shipped with a (four-prong) grounding
plug for your protection against shock hazard and
should be plugged directly into a properly grounded
receptacle. DO NOT cut or remove the grounding
prong from this plug.
n
Prior to connecting the power cord to the wall
socket, inspect the cable for any damage that may
have occurred. In the event of damage, please
consult your electrical installer.
n
Ensure that the power cord is routed so that it
cannot become damaged during the installation.
This appliance must be supplied with the proper voltage
and frequency, and connected to an individual, properly
grounded branch circuit, protected by a circuit breaker or
time-delay fuse, as noted on the rating plate.
Wiring must conform to National Electric Codes. If the electric
service provided does not meet the above specications,
have a licensed electrician install an approved outlet.
Because range terminals are not accessible after the range is
in position, exible service conduit or cord must be used.
13. Electrical connection