Use and Care Guide

CONVERSION
Check the appliance is electrically safe and gas sound when you have nished.
42
Valve adjustment
Disconnect from the electricity supply.
Pull o all the control knobs.
Open the oven door and remove the 3 xing screws
underneath the control panel (Fig. 12.5).
Remove 3 screws from the upper rear of the control panel
Pull the bottom of the control panel forward and lift clear.
Remove the electrical connections from the rear. Taking care
not to damage the control panel, and protecting it with cloth
for example, rest it on the open oven door.
Turn the bypass screw on each control clockwise to the stop
(Fig. 12.6). Connect the electrical connectors to the rear of
the control panel and locate it over the front lip of the hob. Fit
the 6 xing screws and control knobs.
Gas regulator
NOTE: To avoid exterior damage to the storage drawer. Place
a soft cushioned mat on the oor.
To access the gas regulator remove the storage drawer (see
Removing the drawer). Once the drawer has been removed
the regulator is now visible (Fig. 12.7).
For safety reasons slide the drawer runners back into the
cavity.
1. Unscrew the hexagonal nut in the front of the regulator.
The regulator nut has a plastic snap-in converter device
on the underside (Fig. 12.8). To convert the regulator
snap the device out of the nut and replace the other
way up.
2. The snap-in converter device is marked to show which
gas it is set for (Fig. 12.9). Make sure the device is
secure in the base of the nut and replace the nut to the
regulator.
ArtNo.103-0006 - Maxitrol cap & converter
Nut
Snap-in converter device
ArtNo.102-0005 - Gas regulator types
ArtNo.0102-0011 - Screwing
the control valve bypass screw
ArtNo.272-0025 - 90 Aga Professional - Control panel removal
Fig. 12.5
Fig. 12.6
Fig. 12.7
Fig. 12.8
ArtNo.102-0007 - Maxitrol converter device positions
Fig. 12.9
Snap-in converter device
Nut