Use and Care Guide
CONVERSION
Check the appliance is electrically safe and gas sound when you have nished.
41
Orifices
Remove the burner heads. Undo the large brass nuts and
remove the brass venturis and ring, if tted (Fig. 12.1).
Using a long socket wrench slacken o each of the orices,
no more than one full turn.
Using the rubber tubing, provided in the conversion kit, t
over the end of the socket wrench (Fig. 12.2).
Carefully push the open end of the tubing onto the orice
(Fig. 12.3). Unscrew the orice fully and lift clear of the
cooktop.
Save the orices removed from the appliance for future use.
To Install the new orices; see Table 12.1 for orice details.
Insert the new orice into the open end of the rubber tube
which is attached to the socket wrench. Screw into the orice
carrier as far as possible and lift the socket wrench away
(Fig. 12.4).
Remove the rubber tubing from the socket wrench and
tighten all of the orices.
Fit the ring on the burner if tted. Screw in the hexagon
headed venturi to make tting the burners easier. DO NOT
tighten yet.
When all the venturis have been tted tighten the venturi
nuts.
Fig. 12.4
Burner head
Burner Base
Brass Venturi
Burner ring
Table 12.1
Natural Gas Propane Gas
Center burner 205 118
Large Burners 150 99
Right front burner 112 68
Fig. 12.1
Rubber tubing
Fig. 12.2
Fig. 12.3
Burner head
Burner Base
Rubber tubing
Burner Ring
Brass Venturi