Use and Care Guide

INSTALLATION
Check the appliance is electrically safe and gas sound when you have nished.
34
Cooker
Outer stability
bracket
Floor
Wall
3 mm min
Typical wall mounting
ArtNo.070-0014 - Stability bracket - Wall fitting
Cooker
Stability bracket
Floor
3 mm min
Typical oor mounting
Fig. 11.12
Fig. 11.13
Anti-tip device
n
WARNING: The range must be secured using the
anti-tip bracket supplied. Unless properly installed,
the range could be tipped by leaning on the door.
Injury might result from spilled hot liquids or from
the range itself.
When tting an anti-tip device, please refer to the instructions
supplied with the device for further details on tting.
NOTE: The range must be set to the correct height and
leveled before the anti-tip bracket is installed.
Floor fixing
Using the screw supplied, assemble the anti-tip bracket base
and anti-tip bracket extension (Fig. 11.9).
Using suitable screws and xings, attach the assembled anti-
tip bracket to the oor to ensure sucient engagement with
the back of the range.
Adjust and lock the inner anti-tip bracket to give a ⁄” (3 mm)
clearance above the engagement edge in the back of the
range (Fig. 11.10).
Wall fixing
Where oor xing is impractical and provided that the outer
anti-tip bracket can be attached to a solid wall, the anti-tip
device may be attached to a wall (Fig. 11.11). Make sure to
use suitable screws and xings.
Side panel extension kit
Two side extension panels are supplied with the range. These
can be installed where the side of the range is exposed,
preferably during the installation of the appliance.
Procedure
1. Loosen the 2 screws in the rear edge of the range side
panel.
2. Using the cut-outs, site the side extension onto the
protruding screw heads (Fig. 11.12).
3. Push the side extension up so that the tab in the bottom
of the ue extension ts into the slot at the top (Fig.
11.13).
4. Hold the side extension in place and tighten the screws
to secure.
Fig. 11.10
Fig. 11.11
A
B
A
B
Anti-tip bracket
⁄” (3 mm) min
Range
Outer anti-tip
bracket
⁄” (3 mm) min
Range
Fig. 11.9